Nexxt Spine Broken Plate-Screws in Cervical Fusion Surgery Noblesville Indiana

In May 2018, I had a spinal fusion surgery performed in my cervical spine. The hardware (screws & plate) that was used was manufactured by Nexxt Spine. Images taken during my first follow-up post-surgery showed everything was correct and no problems were present. Likewise, all discomfort was gone and most numbing/tingling was gone as well.

Some issues began to arise over the past year or so and I therefore decided to see a neurosurgeon recently in order to request an MRI, CT and x-ray. All images and accompanying reports have revealed two major problems. First, BOTH titanium screws in my C6 vertebrae are broken in half inside the bone. Second, the safety mechanism designed to prevent the screws from backing out has failed, resulting in the screw protruding outward by 4 to 5 millimeters.

If this were just one failure it could maybe be chalked up to a fluke, but there are three failures occurring here simultaneously, and I am consequently faced with a very bad situation and risky decisions involving the cervical spine, not to mention the stress and discomfort.

If you have an upcoming surgery involving spinal implants, I would consider speaking with your surgeon regarding the brand and type of implants he or she will be using. If they tell you it's Nexxt Spine, well...you now know my story, the choice is yours. I promise you this, however, if it is Nexxt Spine and you choose not to say anything, and then should happen to find yourself in a situation similar to mine afterwards, you’ll probably hate yourself.

<br